Hatco HEATMAX RCTHW2 Serie Instrucciones Originales página 11

5. Put the unit into Heat Mode or Hold Mode.
• Heat Mode will keep the heating elements on to
continuously boil the water in the well.
• Hold Mode will keep the unit at the setpoint temperature.
6. Press and hold the Timer button for three seconds to start
the timer.
• After starting the timer, press the Timer button to see
the remaining time.
• When the timer is done, the unit will beep six times, and
the unit will switch to Hold Mode automatically.
NOTE: Refer to "Changing the Timer Settings" in this section
to turn the timer off or to make adjustments.
7. Allow the unit to preheat for approximately 30 minutes.
Shutdown
1. Press the Power I/O button to turn off the unit. The LED
indicator will glow red when the unit is off.
2. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.
Changing the Holding Temperature
Use the following procedure to change the holding temperature.
1. Press the Menu button.
2. Use the up and down arrows to select the desired holding
temperature between 40‒95°C (104‒203°F).
NOTE: The default setting is 95°C (203°F).
3. Press the Menu button or wait six seconds to select
temperature.
RCTHW2CEM-0124
Changing the Timer Settings
Use the following procedure to change the timer settings. The
timer can be turned off or set between 1–180 minutes.
1. Press and hold the Timer button for three seconds to
toggle between one of the following options.
• XXXMIN: The timer is on and can be set between 1–180
minutes.
• OFFMIN: The timer will be off and not shown on the
display.
2. Using the up and down arrows, choose a time between
1–180 minutes.
3. Press the Timer button or wait six seconds to select desired
temperature.
• When the timer is done, the unit will beep six times, and
the unit will switch to Hold Mode automatically.
11
OPERATION