Hatco HEATMAX RCTHW2 Serie Instrucciones Originales página 7

General
HEATMAX Heated Wells are shipped from the factory with
most components assembled and ready for use. Care should
be taken when unpacking shipping carton to avoid damage to
unit and the components enclosed.
Built-in models require installation of the drain valve and
remote mounted control box.
WARNING
ELECTRIC SHOCK HAZARD:
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void unit
warranty and may lead to electric shock or burn, as
well as damage to unit and/or its surroundings.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F).
FIRE HAZARD: Locate unit a minimum of 25 mm (1") from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
NOTICE
Unit is designed and recommended for use in or on
metallic countertops. Damage to any countertop material
is not covered under the Hatco warranty. For other
surfaces, verify with manufacturer that material is suitable
for prolonged temperatures up to 100°C (212°F).
Do not lay unit on the side with the control panel. Damage
to the unit could occur.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit.
1. Remove the unit from the carton.
2. Remove tape and protective packaging from all surfaces
of the unit and any accessories.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
RCTHW2CEM-0124
CAUTION
3. Verify the installation location is appropriate.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 21°C
(70°F). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
4. If the unit is a countertop model, perform the procedure
below:
a. Place the unit in the desired location. Make sure all the
feet on the bottom of the unit are positioned securely on
the countertop.
b. Have a qualified electrician perform the necessary
electrical connections.
5. If the unit is a built-in model, perform the "Installing a
Built-In Model" procedure in this section.
Installing a Built-In Model
Use the following procedures to install a built-in model into a
countertop.
Installing the Drain Valve
Before installing a rectangular model into the countertop,
perform the following procedure to install the drain assembly.
1. Carefully turn over the unit and lay it on its top side.
2. Connect the supplied drain valve to the drain hose using
the supplied hose clamp.
3. After completing installation of the unit, the drain valve may
be connected to an external drain pipe, if desired.
Drain Valve
Installing the Drain Valve (Built-in models only)
7
INSTALLATION
Hose Clamp
Drain Hose