Hatco HEATMAX RCTHW2 Serie Instrucciones Originales página 8

INSTALLATION
Installing the Unit
1. Cut the appropriate opening in the countertop for the unit
being installed (see below).
344 mm
(13-9/16")
RCTHW2-6B Countertop Cutout Dimensions
NOTE: The countertop must be level to ensure proper draining
of the well.
NOTICE
Remote mounted control boxes must have a minimum
152 mm (6") clearance from unit (not to exceed
1420 mm [56"]). Mounting control box closer may cause
heat damage to electrical system in control box.
The remote mounted control box should be installed
outside of heat zone. Locating the control box inside heat
zone will cause the control(s) to overheat, malfunction,
and fail.
2. Cut the appropriate opening for the control box in a vertical
surface at least 152 mm (6") from the unit, but no more
than 1420 mm (56") (see below).
3.5 mm
(1/8")
65 mm
(2-9/16")
Ø 4,5 mm
(3/16")
Control Box Cutout Dimensions
NOTE: The electrical cord between the unit and the control box
is 1420 mm (56") in length.
3. Unplug the control box from the bottom of the unit.
4. Place ribbon putty gasket around the cutout edge of the
countertop. Make sure the ribbon putty gasket overhangs
the cutout edge or seal unit with silicone adhesive.
5. Guide the electrical cord and drain hose through the
countertop cutout, and lower the unit into the cutout.
RCTHW2-3B
550 mm
(21-11/16")
RCTHW2-6B
570 mm
(22-1/2")
135 mm
(5-3/8")
4.5 mm
(3/16")
79 mm
(3-1/8")
144 mm
(6-11/16")
Countertop
Cutout
Control Box
Installing the Unit
6. Assemble the L-brackets to the
underside of the unit.
7. Tighten the L-bracket screws until
the mounting plate lies flat on the
countertop.
NOTICE
Do not use excessive force when
tightening mounting screws on
built-in units. This may damage unit
and/or countertop.
Installing the Remote Control Box
1. With the remote control box unplugged from the unit,
guide the control box cable into the cutout and position the
control box into the cutout opening.
• Align the holes in the control box with the pre-drilled
holes in the mounting surface.
2. Secure the control box to the mounting surface using
screws (not supplied).
3. Plug the control box cable into the unit.
NOTE: Units are equipped with a 1829 mm (6') cable
connecting the control box to the unit.
8
Mounting
Plate
Cutout
Countertop
Mounting
Plate
Screw Screw
L Bracket L Bracket
RCTHW2CEM-0124