American Standard 6030SMRHOL Instrucciones De Instalación página 2

6036SMLHOL
LEFT HAND
4-9/16"
OUTLET
(116mm)
17-3/4"
(451mm)
36"
(914mm)
1"
(25mm)
2"
(51mm)
1
Ensure that the floor and stud walls are square and plumb on a
level floor as shown in Figure A. Provide a 6" x 6" (152 x 152 mm)
opening in the floor for the drain and refer to the product chart for
actual drain location. The lower portion of the drain mount must fit
into the 6" x 6" (152 x 152 mm) opening. Check by dry fitting the
shower base in the final location. Draw a line 3" (76 mm) above the
level subfloor on the wall studs at each side of the opening.
NOTE: Shower pans are to be installed on sub-floors not finished
floors. Shower pans will drain properly provided they are installed
on a level surface.
Check the floor with a long level. A long level is more likely to detect
level of sub-floor at its greatest dimensions. Check front-to-back
at the left and right sides and at the center. Repeat for side-to-side
dimensions. Finally check the diagonals. Depending on the results,
some additional prep work may be necessary.
60"
(1524mm)
FRONT
TOP VIEW
2" (51mm)
THRESHOLD DEPTH
RIGHT SIDE
4836SMCOL
17-3/4"
(451mm)
36"
(914mm)
(25mm)
2"
(51mm)
6036SMRHOL
1"
(25mm)
2"
(51mm)
48"
(1219mm)
24"
(610mm)
FRONT
TOP VIEW
1"
2" (51mm)
THRESHOLD DEPTH
RIGHT SIDE
MARK STUDS 3" ABOVE LEVEL SUBFLOOR
PVC Waste Pipe
FIGURE A
- 2 -
60"
(1524mm)
4-9/16"
(116mm)
FRONT
TOP VIEW
2" (51mm)
THRESHOLD DEPTH
RIGHT SIDE
CENTER
OUTLET
90°
2" (51mm)
C/L
(152 x 152mm)
Opening
(See Product Chart for Drain Location)
RIGHT HAND
OUTLET
17-3/4"
(451mm)
36"
(914mm)
90°
6" x 6"
755438-100 Rev. 4 (4/23)