Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 2,500 PSIHigh Pressure Washer
How
to
Use the Nozzles
_
ANGER!
Never exchange nozzles without
lockingthe safety latch on the trigger.
The quick-connect on the nozzle extension allows you to
switch between five different nozzles. The nozzles vary the
spray pattern as shown below (Figure 18).
Follow these instructions to change nozzles:
• Engagethe safety latch on the spray gun.
• Pull back the collar on the quick-connect and pull the
current nozzle off. Store the nozzle in the space
provided on the handle'sstorage panel.
NOTE: For a more gentle rinse, select the white 40° or
green 25° nozzle. To scour the surface, select the yellow
15° or red 0 ° nozzle. To apply chemical, select the black
nozzle.
• Pull back on the collar,insert the new nozzle and release
the collar. Tug on the nozzle to make sure it is securely
in place.
• For most effective cleaning, keep the spray nozzle
between 8 to 24 inchesaway from the cleaning surface. If
you get the spray nozzle too close, you may damagethe
cleaning surface.
Cleaning
and Applying
Chemical
_i
WARNING!
You must attach all hoses before
you start the engine. Starting the engine without all
the hoses connected and without the water turned
ON will damagethe pump.
IMPORTANT:
Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent follow these steps:
• Review the use of the nozzles.
• Prepare the detergent solution as required by the
manufacturer.
• Hang the detergent solution on the "J" hook attached to
the accessory tray, as shown in Figure 19.
• Placethe small filter end of the detergent siphoning tube
into the detergent container.
Low Pressure
Black
25°
High Pressure
White
Green
Yellow
Red
40°
25°
15 °
0°
/
I0
Publicidad
