Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 2,500 PSIHigh Pressure Washer
Checklist
Before
Starting
Engine
Review the unit's assembly to confirm you have performed
alt of the following:
• Make sure the handle is in place and secure.
• Check that oit has been added to the proper level in the
engine crankcase.
• Add the proper gasoline to fuel tank.
• Check for properly attached hose connections.
• Check to make sure that there are no kinks, cuts, or
damageto the high pressure hose.
• Provide a proper water supply (not to exceed 140°F)at
an adequate flow.
• Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using the pressure washer.
HOW
TO USE YOUR
PRESSURE
WASH ER
If you haveany problems operating your pressure washer,
pleasecatl the pressure washer helpline at 1-800-270-1408.
To Start
Your Pressure
Washer
To start your pressure washer for the first time, follow
these instructionsstep-by-step. This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
• Placethe pressure washer in an area close enough to an
outside water source capable of supplying water at a flow
rate greater than 3.3gallons per minute.
• Check that the high pressure hose is connected to the
spray gun and to the pump. See "Preparing Pressure
Washer for Use" for illustrations.
• Make sure unit is in a level position.
• Connect the garden hose to the water inlet on the
pressure washer pump. Turn ON the water.
_
AUTION!
Oo Not run the pump without the
water supply connected and turned on. You must
follow this caution or the pump will be damaged.
• Squeezethe trigger on the gun until you have a steady
stream of water. This purges the pump of air and
impurities.
• Attach the nozzle extension to the spray gun (Figure I I).
Tighten by hand.
• Choose the nozzle you want to use and insert it into the
nozzle extension. See "How to Use the Nozzles" on
page IO.
• Engage the safety latch to the spray gun trigger
(Figure 12).
Safety Latch
• Rotate the fuel valve lever to the "On" position
(Figure 13).
off
• Move the throttle lever to the "Fast" position
(Figure 14). Controls are shown in the desired operating
condition.
/
8
Publicidad
