Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 2,500 PSIHigh Pressure Washer
IMPORTANT:
Read entire owner's manual before you
attempt to assembleor operate your new pressure washer.
REMOVE
PRESSURE
WASHER
FROM
CARTON
• Remove the parts box packed with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton
Contents
Items in the carton include:
• Main Unit
• Parts Box (which includesthe following):
Safety Goggles
Handle Assembly
Handle Fastening Hardware (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"J" Hook
Chemical Hose Clip
Nozzle Cleaning Kit
High Pressure Hose
Owner's Manual
Engine Manual
Engine Warranty Card
EmissionsControl Warranty Card
Owner's Registration Card
Spray Gun with Quick Connect Fitting
Nozzle Extension with Quick Connect Fitting
Bagcontaining5 mult_olored Quick Connect Nozzles
Oit Bottle
O-Ring Maintenance Kit
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
PREPARING
PRESSURE
WASHER
FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
To prepare your pressure washer for operation, you
will need to perform these tasks:
• Fill out and send in the registration card.
• Attach the handle.
• Add oil to the engine crankcase.
• Add fuel to the fuel tank.
• Connect the high pressure hose to the spray gun and the
pump.
• Connect the water supply to the pump.
• Attach the nozzle extension to the spray gun.
• Select and attach quick connect nozzle to the nozzle
extension.
Attach
Handle
NOTE:
All assembly operations
given in this section will
be described from the perspective of viewing the pressure
washer from the rear.
• Placethe handle assembly onto the handle supports
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure I).
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
/
5
Publicidad
