Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 2,500 PSI High Pressure Washer
O-Ring
Maintenance
Through the normal operation of your pressure washer,
o-rings, which keep the connections of the hoses and spray
gun tight and leak-free, may become worn or damaged.
Provided with your pressure washer is an O-Ring
Maintenance Kit which includes replacement o-rings,
rubber washer and water inlet filter. Refer to the
instruction sheet provided in the kit to service your unit's
o-rings. Note that not all of the parts in the kit will be used
on your
unit.
To remove
a worn or damaged
o-ring:
•
Use a small flathead screwdriver
to get underneath
the
o-ring and pry it off.
ENGINE
MAINTENANCE
See the engine owner's manual for instructions on how to
properly
maintain the engine.
PREPARING
THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days, follow this
procedure:
I.
Flush detergent siphoning tube by placing the filter into
a pail of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2.
Shut off the engine and let it cool, then remove all
hoses. Disconnect spark plug wire from spark plug.
3.
Empty the pump of all pumped liquidsby pulling the
recoil handle about 6 times. This should remove most
of the liquid in the pump.
NOTE: To protect the unit from freezing temperatures,
draw RV antifreeze (non-alcohol) into the pump by pouring
the solution into a 3-foot section of garden hose connected
to inlet adapter and pulling recoil handle twice.
4.
Store unit in a clean, dry area.
STORING
THE
ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
I
14
Publicidad
