Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 2,500 PSIHigh Pressure Washer
_
AUTION!
Keep the chemical injection tube
from coming in contact with the hot mumer.
• Make sure the black nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (White, Green, Yellow, or Red).
• Make sure the garden hose is connected to the water
inlet. Check that the high pressure hose is connected to
the spray gun and the pump and start the engine.
• Apply the detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes. Do Not allow the
detergent to dry on (prevents streaking).
• Allow the detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to prevent
surface from drying.
Pressure
Washer
Rinsing
_
ARNING!
Be extremely careful if you must
use the pressure washer from a ladder,scaffolding
or any other relatively unstable location. Hose
water pressure builds as you climb. When you press
the trigger, the recoil from the initial spray can be
very strong. The high pressure spray could cause
you to falt if you are too close to the cleaning
surface.
After
you have applied
detergent,
scour the surface
and rinse
it clean as follows:
• Apply safety latch to spray gun.
• Remove the black chemical nozzle from the nozzle
extension.
• Select and instaltthe desired high pressure nozzle
following the instructions"How to Use the Nozzles" on
page 10.
• Keep the spray gun a safe distance from the area you
plan to spray.
• Increase or decrease spray pressure by turning the
pressure control knob counterclockwise or clockwise
respectively (Figure 20). Use lower pressure to wash
itemssuch a as a car or boat. Use higher pressure to
strip paint and degrease driveways.
Pressure
Control
Knob
• Apply a high pressure spray to a small area and then
check the surface for damage. If no damage is found, you
can assume it isokay to continue cleaning.
• Start at the top of the area to be rinsed, working down
with same overlapping strokes as you used for cleaning.
Automatic
Cool
Down System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach a temperature
between 140-145°E At this temperature, the system
engagesand cools the pump by discharging the warm
water onto the ground. This system prevents internal
damage to the pump.
/
II
Publicidad
