Publicidad
Idiomas disponibles
Idiomas disponibles
Cautions
• Do not use the machine in the rain or snow.
• Do not touch the electrodes or welding accessories with your bare hands.
• Always wear insulated welding gloves, making sure they are dry and in good condition, without breaks or perforations.
• Electrically isolate the work area so that people are protected. Do not remove the case of the machine or manipulate it
internally when it is connected to the power supply.
• Only connect the machine to a 220 Volt 50 / 60Hz AC power source.
• Make sure the power board has the 60 Amp thermomagnetic switch and the ground connection properly connected.
• Make sure the power cord is properly connected to the electrical outlet. If you do install a plug, be sure to respect the
cable color codes. This should not be modi ed in any way, use plugs in accordance with the standard to reduce the risk
of electric shock.
• Turn o the equipment when you nish your work and disconnect it from the electrical outlet.
• Do not leave the equipment connected to the electrical outlet or with the switch in the ON position without attention.
• Only place the electrode holder clamp or torch on an insulated surface regardless of whether the electrode connected
or not. Avoid shorting with the work clamp (ground). Remove the electrode from the electrode holder if the welding
process is interrupted or has ended.
• Place the machine switch in the OFF position at the rear of the equipment and disconnect the power cord from the
electrical outlet each time changes are made in the work area, when removing the electrode holder, torch, or clamp.
work (ground) and when transporting or cleaning equipment.
• Pay special attention to the condition of the power cable, if the cable is damaged, repair it with a quali ed electrician,
PREFERENTLY take it to an Authorized Service Center by UJUETA MÉXICO, S.A. DE C.V.
2
YEAR
WARRANTY
Publicidad
