Publicidad
Idiomas disponibles
Idiomas disponibles
Connection for TIG
Argon gas from a cylinder with a ow regulator must be used for this gas. The torch must be connected directly to the
regulator. The equipment does not have an electrovalve to control the gas ow, so the use of a torch with a knob is
recommended for regulation and interruption of gas ow.
It is recommended to adjust a gas ow of 10 to 20 l / m or 21 to 40 CFH.
The arc start mode in TIG is SCRATCH, which means that to start the arc it is necessary to scratch the tungsten electrode
against the piece and separate it, as shown in the following images:
1JF[B
1. Place the torch in position
Service and Maintenance
Maintenance
The welder has been built for long periods of use with a minimum of maintenance. The operation of the machine in the
long term with satisfactory performance depends on the correct care of the machine and its periodic cleaning.
Cleaning - unplug machine before cleaning
Periodically clean the welder using a soft cloth, preferably after each use. Keep the vents free of dust and dirt and if they
cannot be easily removed use a damp cloth with water and a little soap. Never use solvents derived from petroleum,
alcohol, etc. they can damage the plastic parts of the machine.
1JF[B
2. Slightly scratch the tungsten
against the
15
NN
1JF[B
3. Separate the tungsten from 2
to 4 mm to start the arc
YEAR
WARRANTY
Publicidad
