Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Your authorized dealer will assist you with assembly.
1. Check the cardboard box for damage before unpacking. If the contents are damaged, contact your dealer
immediately.
2. Remove all parts from the box and place them within reach.
3. Unfold the rollator and lock the seat into place. To do this, pull the red lever located on the right side of the
rear frame. The rear leg supports can now be pulled backward from the main frame. Ensure that the lever
clicks into place and proceed gently to avoid injury. To fold the rollator back, press the lever. This will release
the locking mechanism.
4. Remove the caps from the upper ends of the rollator frame and insert the bars with handles/brake handles
into the ends. The handles must be parallel to the direction of travel.
5. Adjust the height and place the tension screw into the clamp. Make sure the washer remains directly on the
screw. Release the red button of the tension locks so that they click into place. Then tighten the nut of the
screws.
Using Brakes and Locking Brakes
•
Always use both brakes/locking brakes simultaneously.
•
To briefly slow down or stop the rollator, apply the brakes by pulling both brake levers
upward until you reach the desired speed or come to a stop.
•
To engage the locking brakes, press both brake levers downward simultaneously—do
not use excessive force or pressure—until they click into place.
•
To disengage the locking brakes, pull the brake levers upward simultaneously until they
release from the locked position.
•
Brake effectiveness can be adjusted directly at the brake lever (a) or the brake cable (b).
Revision 2023/12
7
Publicidad
