Publicidad
Idiomas disponibles
Idiomas disponibles
8. Construct the Framing - Recess-Mount Installation
NOTE: The following instructions are for recess-mount installation only. For surface-mount installation, refer to the
"Surface-Mount Installation" sections.
Mark the cutout opening based on your models dimensions from the table below.
Use a jigsaw or keyhole saw to carefully remove the finished wall material from the marked cutout location.
Determine the electrical wire hole location according to the dimensions shown in the "Roughing-In" section.
Verify that there is enough electrical wire to reach the junction box inside the cabinet.
Frame the wall cavity. If needed, install a header.
Secure the drywall to the framing.
Cutout Size
Cabinet Model
Showcase Side
Cabinet
Kohler Co.
W
X
W (Height)
30-3/4" (781 mm)
Y
Z
X (Width)
11-5/16" (287 mm)
13
Y (From Wall Surface) Z (From Bottom of
1" (25 mm)
Cutout)
7-7/16" (189 mm)
1558797-2-B
Publicidad
