Publicidad
Idiomas disponibles
Idiomas disponibles
Roughing-In
Mounting-Hole Locations - Surface-Mount Installation
Wiring-Hole Locations
For surface-mount installation, location of the wiring-hole is on the non-hinge side. The center of the wiring-hole should
be 3/8" (10 mm) from the side of the cabinet. Drill a 3/4" (19 mm) hole in the wall for the electrical wires.
For recess-mount installation, electrical wires should enter the cabinet at the location indicated. Electrical wiring may be
routed behind the cabinet or along the top or side of the cabinet.
Kohler Co.
31-1/16"
(789 mm)
7-7/8"
(200 mm)
3/8" (10 mm)
RIGHT DOOR SWING
6-5/8"
(170 mm)
6-5/16"
(160 mm)
LEFT DOOR SWING
5
7-7/8"
(200 mm)
3/8" (10 mm)
1558797-2-B
Publicidad
