Publicidad
Idiomas disponibles
Idiomas disponibles
1. Prepare the Site
WARNING: Risk of electric shock. Disconnect the power before performing the following procedures.
WARNING: Risk of electric shock. A qualified electrician should route all electrical wiring.
IMPORTANT! Use anchors (not provided) that are rated for the load weight of this product. Refer to the anchor
manufacturer's instructions.
When determining the height of the product, verify that the door will clear all obstacles (such as a faucet or light
fixture). Provide a minimum distance of 3" (76 mm).
Identify and mark stud locations.
Measure and mark the mounting-hole locations for the bottom hanger(s) and top retaining clips according to the
"Roughing-In" section.
Determine the electrical wire hole location according to the dimensions shown in the "Roughing-In" section.
Location of wiring holes for surface-mount cabinets is on the non-hinge side.
Drill a 3/4" (19 mm) hole in the wall for the electrical wires.
Route the electrical supply wires through the hole in the finished wall.
X
Less than 36" (914 mm)
1558797-2-B
Z
Y
X
Y
Greater than 1" (25 mm)
3" (76 mm)
3" (76 mm)
Z
7-7/8" (200 mm)
6
Kohler Co.
Publicidad
