Shark StainStriker PX200 Manual De Instrucciones página 4

WET STAIN CLEANING
1. For Wet Stains, follow the Stain Guide
located on the hand tool. Turn ON using
the power button and vacuum up the liquid
mess. Spray the stain area. Scrub with the
bristles, then tilt hand tool forward and
drag across the stain area to extract liquid.
Repeat if needed. To avoid longer dry times,
do not over spray.
Note: For hard to reach areas, tool can be used without a hand tool attachment using only the crevice
tool set up.
Tip: Choosing the bristles - The rubber bristles are best suited for more delicate surfaces and
upholstery. The tough bristles are ideal for stubborn agitation on hard wearing surfaces.
PET STAIN TRAPPING TOOL
The Shark Pet Stain Trapping Tool is included with select models. This extracts unhygienic
messes, preventing the mess from reaching the hose and the interior of the unit. DO NOT use
the tool to remove pet hair. To use, spray the wet mess, then extract it as advised above. To
avoid oversaturating, do not over spray. DO NOT exceed the MAX FILL line on the Pet Tool
Cup.
Keep the tool level, without tipping to prevent the mess from reaching the hose. After use,
turn off the power of the main unit and empty the tool cup where appropriate. Wash the cup,
filter, and the rest of the tool thoroughly with soap and water after each use.
Cup
6
s h a r kc l e a n . e u
DRY STAIN CLEANING
1
2. For Dry stains, follow the Stain Guide
located on the hand tool. Turn ON using
the power button. Scrub the stained
area, then spray and scrub again, then
tilt hand tool forwards and drag across
the stain area to extract liquid. Repeat
if needed. To avoid longer dry times, do
not over spray.
2
1. Detach the dirty water tank. keeping
the tank upright and set down on a level
surface. Push the handle all the way back
until it clicks, then lift off the lid.
3. Suitably pour away the dirty liquid from
the dirty water tank, tapping off any
loose debris. Clean off any other debris
on the hand tools, bristles, lid and float
valve. Rinse all parts thoroughly with
soap and water and allow to air-dry
completely before reinstalling.
5. To clear any clogged debris, remove the
connecting clip on the bottom of the unit.
Clear all debris, then close the door.
NOTE: Clean unit after every use to avoid odours, bacteria, and mould.
Filter
MAINTENANCE
1
2. Clean the float valve and make sure it can
move freely. Remove the foam filter from
the unit whilst cleaning.
3
4. Detach the hand tool by pressing the
release button. Remove the cover from
the hand tool to clean the air path. Wash
the bristles on the hand tool thoroughly.
5
s h a r kc l e a n . e u
2
4
7