Publicidad
Idiomas disponibles
Idiomas disponibles
DIAGNOSTIC-LED
Fingerprint LED
Red:
Purple: Rejected
Rejected
(too many attempts,
please wait 30 seconds
and try again)
Door Opener and RFID LED
Red: Rejected
DIAGNOSTIC SOUNDS
The device may emit brief diagnostic sounds after
it has been connected to power supply / network /
Internet, e.g. upon boot process finished, press of a key,
WiFi Setup Mode enabled, RFID Reader detected tag,
Relay triggered.
TAMPER SENSOR
The device has a built-in tamper sensor that can
be configured via the app to send an alert over the
network (e.g. a push notification) if the device is
moved during operation.
BLUETOOTH TRANSCEIVER
The device has a built-in Bluetooth® transceiver.
Compatible with the DoorBird Bluetooth Keyfob
Remote A8007.
DOORBIRD CONNECT
The device features many options to integrate it into
third-party applications. For information, terms and
conditions see www.doorbird.com/connect
Green:
Authorized
Green: Authorized
MAINTENANCE FOR DOORBIRD PRODUCTS
Cleaning and maintenance instructions
All DoorBird door stations are made of high-quality
materials and are designed for a durable lifetime.
Since door stations are usually installed in unprotected
outdoor areas, they are exposed to adverse weather
conditions and aggressive substances, especially close
to frequently used roads, in coastal and industrial
areas. Therefore please consider the following care
instructions. Unfortunately, we cannot accept any
liability for damage if these instructions are not being
observed.
Aggressive dirt such as bird droppings should be
removed as quickly as possible.
Never use abrasive detergents such as steel
NOTI CE
wool or scouring milk!
Warm water is usually sufficient, if necessary with
a little detergent, a soft cloth or brush. Plastic parts
(camera or name tags) must not be treated with
metal care products. Remove all residues of cleaning
agents or lubricants to avoid stains or discolouration
after the maintenance.
Stainless Steel
Only high-quality German stainless steel is used for all
available DoorBird door stations. However, high-quality
stainless steel can also rust, as approx. 70 % of stainless
steel is made of iron. Rust resistance is only achieved
by a protective layer (also called passive layer), which
covers the iron like a skin. This protective layer consists
essentially of chromium and other precious metals.
Iron particles, grinding dust and chips deposited on
stainless steel can lead to corrosion (rust film). These
iron particles can be found everywhere, but especially
in coastal and industrial areas and close to frequently
used roads. Please remove ferrous deposits immediately,
as they will attack your door station and lead to real
rust if not removed. To remove rust, simply wipe off the
dust; in addition, a care product is recommended, e.g.
WD 40, available e.g. at Amazon for less than € 5.00.
Simply apply in a thin layer and rub in. The same applies
if rust appears on the engravings on the stainless steel
surface.
Cement or lime splashes should be carefully removed
as soon as possible with a wooden spatula before
hardening.
The following cleaning detergents are not to be used
as they reduce corrosion resistance:
•
products containing chloride and hydrochloric
acid
•
Bleach (in case of accidental use, rinse thoroughly
with water)
•
Silver polish
15
Publicidad
