Publicidad
Idiomas disponibles
Idiomas disponibles
After the cleaning with clear water wipe with damp
cloth and rub dry to avoid lime traces. Lime residues
can be avoided by using demineralised water.
Stainless steel PVD coated
PVD coated, chrome-plated or gold-plated surfaces
are recommended to be cleaned with a grease-
dissolving detergent and clear water or with a clean
and dust-free microfibre cloth. For high-gloss surfaces,
use a scratch-free cloth (e.g. cleaning cloth for glasses,
furniture polishing cloth, etc.).
Lacquered surfaces
Clean painted surfaces and lettering with a soft,
scratch-free cloth moistened with a mild soap solution
(e.g. cleaning cloth for glasses, furniture polishing cloth,
etc.). To prevent stains or discolouration, the detergents
should be wiped off without leaving any residue.
Be particularly careful with lettering in order not to
damage the film or the print.
Real burnished brass and architectural bronze
The surface finish „real burnished brass" and
„architectural bronze" is a cold burnished finish, which
is sealed with a boat wax. As the surface is open to
diffusion, it is advisable to apply a subsequent layer of
wax at intervals (approx. 6-18 months) using a soft cloth
(flow cloth), allow it to soak in for a while and then rub
it evenly dry with a dry cloth. We recommend a wax
such as Teroson WX 990 by Henkel.
Chemical cleaning agents of any kind must NOT be
used.
Avoid touching the surface with your fingers during
installation. Wearing powder-free latex gloves is
recommended.
Depending on the weather conditions, the processed
surface may change, forming its characteristic,
individual appearance.
16
Publicidad
