Publicidad
Idiomas disponibles
Idiomas disponibles
VIDEOS
Need help with the installation? Be sure to watch our
installation videos which can be found on
http://www.doorbird.com/support
Each individual step of the installation is clearly
documented in the videos.
INSTALLATION
All the steps below should be carried out carefully
by a competent adult, taking into consideration
any applicable safety regulations. Please contact us
directly or seek the advice of a competent specialist.
Please ensure that all wires used for the
installation are undamaged along their entire
length and approved for this type of use.
Network speed and network components
Please ensure that the upload speed of your Internet
connection is at least 0.5 Mbps. The user experience is
only as good as your network speed, network stability
and quality of your network components, such as
your Internet Router and WiFi access points or WiFi
repeaters. Please also make sure that your network
components are no older than two years old, have
been manufactured by a well-known manufacturer,
and have the latest firmware installed.
Should these requirements not be fulfilled, it may
occur that push notifications are delayed or not
delivered to your mobile device.
Requirements:
High-speed Internet (via landline): DSL, cable or optical
fibre
Network: Ethernet, with DHCP
1
SWITCHING OFF POWER
Switch off the power to all wires leading to
the assembly location, e.g. power supply for
the device or an electrical door opener.
DISMANTLING THE EXISTING
2
ACCESS CONTROL DEVICE
Should there already be an access control device on
the exterior wall of the house, please remove it.
DETERMINING THE ASSEMBLY
3
LOCATION
Do not expose the device to direct sunlight.
The housing temperature can exceed the
maximum allowed temperature limit. This can
result in damage of electric and mechanic
components of the device and injuries
especially when touching exterior parts of the
device. White and bright silver-colored front
plates absorb less sunlight than dark ones.
Any defects caused by direct sunlight are not
covered by warranty.
Important note for cavity mounting (e.g. in
pedestals and mailboxes):
To protect the electronic units, please
ensure that the technical components are
protected against dripping and running
water caused by condensate or entering
the mounting space through openings.
To protect the electronic units, ensure
that the mounting space inside is not
accumulating water.
Sufficient air circulation must be ensured,
as well as unobstructed drainage of water
at the base of the installation.
Failure to do so will result in warranty being
declined.
7
Publicidad
