Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V,..................
volts
Hz ................ hertz
min ............... minutes
= = =, ............ direct current
(_) .................
Class l Construction
(grounded)
[] .................
Class II Construction
(double
insulated)
............ Read instruction manual before use
G .................
Use proper eye protection
A ...................
amperes
W ..................
watts
................ alternating
current
no ..................
no load speed
O ..................
earthing
terminal
Z_ ................ safetv alert symbol
,_/min or rpm_,revolutions
or
reciprocation
per minute
..................
Use proper respiratory
protection
O ..................
Use proper hearing
protection
UMPORTANT
SAFETY
UNSTRUCTUONS FOR BATTERY
CHARGERS
SAVE THESE
iNSTRUCTiONS:
This manual contains
important
safety instructions
for
battery chargers=
° Before using charger,
read all instructions
and cautionary
markings
on charger, battery pack, and
product using battery pack.
Z_WARNING:
Shock hazard. Do not allow any liquid to get inside charger.
z_ CAUTION:
Burn hazard. To reduce the risk of injury, charge only designated Craftsman _'R_
batteries. Other types of batteries may burst causing personal injury and damage.
z_ CAUTION:
Under certain conditions, with the charger plugged in to the power supply, the
charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not
limited to, steel woo!, aluminum foi!, or any buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
, DO NOT attempt
to charge
the battery
pack with
any chargers
other than the ones in this
manual.
The charger
and battery pack are specifically
designed
to work together,
, These chargers
are not intended
for any uses other than charging
designated
Craftsman
®
rechargeabte
batteries.
Any other uses may result in risk of fire, electric shock or electrocution.
, Do not expose
charger
to rain or snow.
, Pull by plug rather
than cord when
disconnecting
charger.
This will reduce
risk of damage
to
electric plug and cord,
° Make sure that cord
is located
so that it will not be stepped
on, tripped
over, or otherwise
subjected
to damage
or stress.
, Do not use an extension
cord unless
it is absolutely
necessary.
Use of improper
extension
cord
could result in risk of fire, electric
shock, or electrocution,
, An extension
cord
must have adequate
wire size (AWG or American
Wire Gauge)
for safety.
The snarler
the gauge
number
of the wire, the greater
the capacity
of the cable, that is 16 gauge
has more capacity
than 18 gauge,
When using more than one extension
to make up the total length,
be sure each individual
extension
contains
at least the minimum
wire size,
Publicidad
