Publicidad
Idiomas disponibles
Idiomas disponibles
BReAN
MODELS
EW5830SS
,, EW5836SS
Page
2
MEASURE
THE INSTALLATION
ROOF CAP
/
ROUND
ELBOW
J
////////////////////////////////-_/-_/_
_
._
WALL CAP
DECORATIVE
FLUE _
HOOD MOUNTING
3'/2" FROM WALL TO
II
I !
_
BRACKET
CENTER
LINE OF DUCT _
ql"
(NOTE:
CENTERLINE
OF
II
I I
BLOWER
IS 3_"
LEFT
OF
II
I
i
'_
CENTERLINE OF HOOD.)
f_........_
12 3/8"
TO CENTER
DECORATIVE
FLUE/"
OF UPPER
BRACKET
_L j_
HOOD --H_E--tJL
1 5/8"
, " ,
T
'
---_
2"
TO CENTER
OF LOWER HOOD
24"
TO
36"
ABOVE
CHASIS
HOLES
COOKING
SURFACE
t
The minimum hood distance above cooktop MUST NOT BE
LESS than 24':
A maximum of 36" above cooktop is highly recommended
for
best capture of cooking impurities.
Distances
over 36" are at the installer and users discretion;
providing that the ceiling height permits.
INSTALL
THE DUCTWORK
(Ducted
Hoods Only)
1. Decide where the ductwork will run between the hood and
the outside.
2. A straight, short duct run will allow the hood to perform most
efficiently.
3. Long duct runs, elbows and transitions will reduce the
performance of the hood. Use as few of them as possible.
Larger ducting may be required for best performance with
longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
NOTE
Centerline of duct connector on hood is 3/4,, to the left of the
centerline of the hood - plan duct rough-in accordingly.
PREPARE THE HOOD
Unpack hood and check contents. You should receive:
1 - Hood Assembly
1 - Decorative Flue Assembly (consisting of upper and lower
flue)
1 - Upper Flue Mounting Bracket
2 - Aluminum Grease Filters (installed on hood)
2 - 35W MR16 GU10 Halogen Lamps (installed on hood)
1 - Parts Bag containing:
6 - Mounting Screws (4mm x 38mm Cross Recessed Pan Head)
2 - Mounting Screws (4mm x 12mm Cross Recessed Pan Head)
1 - Suction Cup Tool
1 - Installation Manual
FLUE MOUNTING
BRACKET
2 MOUNTING
SCREWS
(4mm x 12mm
Cross Recessed
Pan Head)
BULB
SUCTION
CUP TOOL
6 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
Pan Head)
DECORATIVE
FLUE
ASSEMBLY
HOOD
ASSEMBLY
Publicidad
