Publicidad
Idiomas disponibles
Idiomas disponibles
BmeAm +
MODELS
EW5830SS
,, EW5836SS
Page
6
°,,.ou.op.E.uM I
FLEXIBLE
METAL DUCT
DUCT LENGTH
DECORATIVE
--_
FLUE
_'
t
6. Align the two outer keyhole slots on the hood with the
mounting screws that were partially tightened
into the wall
framing. Ensure that hood is seated entirely on mounting
screws and that hood is level.Then tighten screws completely.
11. Measure
and install section
of flexible
metal
ductwork
(included with RKE58) to hood duct connector and bottom
of non-duct plenum. Use duct tape to make all joints secure
and air tight.
CAUTION
Do not use plastic duct.
12. Plug power cord into wall outlet.
7. Install (2) 4mm x 38mm long screws into the holes inside the
hood and tighten them securely.
8. Attach (2)filter trays to bottom of hood using (8).188" x .375"
mounting screws.
J
O
O
&
&
&
&
9.
Snap in 2-non-duct filters into filter trays by engaging filter
tab on side, rotating upward, and pressing firmly on (2) filter
clips.
10. Reinstall grease filters by aligning rear filter tab with slots
in the hood. Pull down the metal latch tab, push filters into
position and release. Make sure filters are securely engaged
after installation.
13.
14.
15.
Slide the upper
decorative
flue section
into the lower
decorative flue section.
NOTE
For non-ducted
applications,
the
upper flue should
be
oriented so the louvers are towards the ceiling.
Carefully
place the upper/lower
flue assembly
into the
recessed area of the hood.
Slide the upper flue upward until it is aligned with the non-
duct plenum.The
non-duct plenum should be inside the flue.
Secure the upper flue to the non-duct plenum using (2) 4ram
x 12mm mounting screws.
NOTE
9-10
ft. ceilings
may
require
Flue
Extension
Model
FXNE58SS
depending
on installation
height (purchase
separately). Discard the upper and lower flues supplied with
your hood and replace them with Flue Extension
Model
FXNE58SS.
Publicidad
