Broan Elite EW5830SS Manual Del Usuario página 5

BmeAm +
MODELS EW5830SS ,, EW5838SS
Page 5
INSTALL THE HOOD
+ (Non-Ducted Hoods Only)
10. Slide the upper decorative flue section into the lower
decorative flue section.
NOTE
For ducted applications, the louvers on the upper flue should
be hidden by positioning the louvers down, inside of the
lower flue.
11. Carefully place the upper/lower flue assembly into the
recessed area of the hood.
12. Slide the upper flue upward until it is aligned with its mounting
bracket. The bracket should be inside the flue. Secure the
upper flue to the upper flue mounting bracket using (2) 4mm
x 12mm mounting screws.
NOTE
9-10 ft. ceilings may require Flue Extension Model FXNE58SS
depending on installation height (purchase separately).
Discard the upper and lower flues supplied with your hood
and replace them with Flue Extension Model FXNE58SS.
NON=DUCT KIT MODEL RKE58 CONTENTS
NON-DUCT PLENUM
ASSEMBLY
FLEXIBLE DUCT
2 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
PanHead)
8 MOUNTING
SCREWS
(.188"x.375" _:::_
Cross
Recessed
Flat
Head) _/
I
FILTER TRAYS
NON-DUCTED RECIRCULATION FILTERS
NOTE
Non-ducted installations require Non-Duct Kit, Model RKE58
(purchase separately).
Ceiling
Flush with _
the ceiling +_
+
I
Center of
installation
1. Center the non-duct plenum over the hood location and flush
with the ceiling. Secure the non-duct plenum to the wall using
(2) 4ram x 38ram mounting screws. Note: Drywall anchors
may be needed (not included).
2. Tighten the screws completely. Make sure that the non-duct
plenum is tight against the wall and ceiling.
3. Remove damper flaps from damper / duct connector and
discard flaps.
4. Remove the protective plastic film covering the decorative
flue and the hood at this time.
5. Remove the grease filters by pulling down the metal latch tab
and tilting filters downward to remove.