Publicidad
Idiomas disponibles
Idiomas disponibles
1. Apply about three wraps of plumber tape in clockwise
1. Apply about three wraps of plumber tape in clockwise
1. Apply about three wraps of plumber tape in clockwise
DO NOT OVER-TIGHTEN.
subtract 1-inch if you are installing on 3/4-inch pipe, or 1-1/2 inches if
subtract 1-inch if you are installing on 3/4-inch pipe, or 1-1/2 inches if
subtract 1-inch if you are installing on 3/4-inch pipe, or 1-1/2 inches if
you are installing on 1-inch pipe. Mark section of pipe to be removed.
you are installing on 1-inch pipe. Mark section of pipe to be removed.
you are installing on 1-inch pipe. Mark section of pipe to be removed.
4. Turn off the main water supply valve and open a faucet on the
4. Turn off the main water supply valve and open a faucet on the
4. Turn off the main water supply valve and open a faucet on the
lowest level of your home to drain the system. Cut the correct
lowest level of your home to drain the system. Cut the correct
lowest level of your home to drain the system. Cut the correct
length of pipe. Use a pipe cutter or hacksaw. File or sand the
length of pipe. Use a pipe cutter or hacksaw. File or sand the
length of pipe. Use a pipe cutter or hacksaw. File or sand the
ends of the pipe to make sure they are smooth and square.
ends of the pipe to make sure they are smooth and square.
ends of the pipe to make sure they are smooth and square.
NOTE: Have a bucket handy to catch any water
NOTE: Have a bucket handy to catch any water
NOTE: Have a bucket handy to catch any water
that may come out of the pipe.
that may come out of the pipe.
that may come out of the pipe.
opening marked "IN" is facing the incoming water supply. It
opening marked "IN" is facing the incoming water supply. It
opening marked "IN" is facing the incoming water supply. It
assembly. Using two adjustable wrenches, hold incoming
assembly. Using two adjustable wrenches, hold incoming
assembly. Using two adjustable wrenches, hold incoming
adapter securely with one wrench and tighten nut with
adapter securely with one wrench and tighten nut with
adapter securely with one wrench and tighten nut with
second wrench. Repeat procedure for outgoing adapter.
second wrench. Repeat procedure for outgoing adapter.
second wrench. Repeat procedure for outgoing adapter.
pressure-relief button on cap to release trapped air. Check for
pressure-relief button on cap to release trapped air. Check for
pressure-relief button on cap to release trapped air. Check for
WARNING
Risk of electrical shock. If your water pipes are
WARNING
WARNING
Risk of electrical shock. If your water pipes are
Risk of electrical shock. If your water pipes are
used to ground your house' s electrical system, install a No. 8 AWG
used to ground your house' s electrical system, install a No. 8 AWG
used to ground your house' s electrical system, install a No. 8 AWG
DO NOT OVER-TIGHTEN.
DO NOT OVER-TIGHTEN.
262.634.2386 | greatlakesintl.com
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
Pentair LR-BB50 Installation and Operation Manual • 5
Pentair LR-BB50 Installation and Operation Manual • 5
Pentair LR-BB50 Installation and Operation Manual • 5
Publicidad
