Publicidad
3
INSTALLATION OF INDOOR UNIT
Installation of ceiling panel (Sold separately)
Install the ceiling panel according to Installation Manual after piping/wiring work has completed.
Check that installation of indoor unit and ceiling opening part is correct, and then install it.
Connect the connecting sections of ceiling panel and ceiling surface, and the ceiling panel and indoor unit closely.
If there is clearance, air leakage generates resulting in dewing or water leakage.
Indoor unit
Lower side of
pattern sheet
Match on the same level.
Installation of remote controller (Sold separately)
For installation of the wired remote controller, follow the Installation Manual attached with the remote controller.
For installation of the wireless remote controller, follow to the Installation Manual attached to the remote controller.
• Do not put the remote controller on the place where is exposed to direct sunlight or near a stove, etc.
• Operate the remote controller, check the indoor unit surely receives the signal, and then install the remote
controller. (Wireless type)
• Install the remote controller 1m apart from the devices such as TV or stereo. (Image may be disturbed or noise
may be output.) (Wireless type)
REQUIREMENT
Lower surface
of ceiling
Indoor unit
Protruding : 0mm or more
9
Indoor unit
Drawing : 3mm or less
Publicidad
