Simpson Strong-Tie Timber Drive Manual Del Operador página 4

Timber Drive
1. Insert the drive bit into the mandrel.
To expose the driver bit, compress
b)
tool by pressing downward on Depth
Adjustment Dial.
2. Identify screw length setting.
3. Set both Upper and Lower
Screw Length Adjustments.
n
m
4
© 2023 Simpson Strong-Tie Company Inc. T-F-TIMBRDRV23 8/23
Tool Setup Steps
™
1
2
D
1
C
B
A
1
3
2
D
C
B
A
2
4
D
C
B
3
A
3
5
4
Remove orange knobs on Upper Screw Length Adjustment. Set
both Upper and Lower Screw Length Adjustments Brackets to
the same setting (A, B, C or D) corresponding to the length of the
screw being driven. Reinstall orange knobs on Upper and Lower
Screw Length Brackets.
4
a) Remove orange knobs and
Lower Screw Length Adjustment Bracket.
Replace driver bit (6-Lobe or Hex).
c)
Driver bits are included with
every pack of screws.
D
6
D
(160mm)
MAX.
D
C
C
B
C
B
A
B
A
Use Screw Length Guide on
A
D
D
3 Timber Drive as reference.
C (75mm)
MIN.
C
B
B
A
A
in
mm
TimberDrive
™
D
C
B
A
1
2
D
C
B
A
3
4
5
D
C
B
A