Simpson Strong-Tie Timber Drive Manual Del Operador página 6

Operating Instructions
1. Insert a single (ONE) screw down the loading tube and position the
nosepiece to the desired fastening location.
2. Place driver motor forward/reverse switch in
forward position.
Pull the trigger and then push down on
the driver motor and tool until the screw
head is seated.
3. Adjust the countersink depth as needed.
n
m
6
© 2023 Simpson Strong-Tie Company Inc. T-F-TIMBRDRV23 8/23
1
2
D
C
B
Note: Do not insert more than one (1) screw at a time into
A
the loading tube as it may cause the tool to jam. If multiple
screws are in the loading tube, simply invert the tool and
allow the screws to fall out.
3
4
5