Antar AT52304 Manual De Usuario página 13

ENG
TECHNICAL DATA
Overall size (Length*Width * Height): 1005*670*960 mm
Seat height: 520 mm
Seat width: 450 mm
Seat depth: 450 mm
Armrest height: 200 mm
Backrest height: 440 mm
Ba ery weight: 2.5 kg
Weight of wheelchair with ba ery: 36 kg
Maximum speed: 6 km/h
Braking distance at 6 km/h: ≤ 1500 mm
Max. turning radius ≤ 1200 mm
Payload: 120 kg
Approximate range on a single charge: 20 km
Sta c stability: ≤ 9°
Dynamic stability: ≤ 6°
Maximum angle of eleva on: 6°
Motor specifi ca on: 24V/250W*2
Ba ery specifi ca on: 24V/12Ah*1
Maximum power supply to the controller: 50A
Ba ery supply current: 2A
Front wheel: non-infl ated tyres, outside diameter 190 mm
Rear wheel: pneuma c tyres, outer diameter 406mm
THIS SIGN INDICATES THE MAXIMUM
WEIGHT OF THE USER
NOTE: It is forbidden to stand on the footrests as this can lead to a dangerous fall and injury.
MONTAGE
1 Remove the wheelchair from the packaging and place it on the ground. Pull the chair frame apart in
opposite direc ons and press the two tubes on either side of the seat base down into the grooves on
either side of the frame. (fi g. 2)
2. Pull the handle upwards, blocking the folding of the wheelchair backrest. (fi g. 3)
3. Connect the plug of the ba ery cable to the socket located in the frame under the seat. (fi g.4)
4. Remove the screws from the controller base, then mount the controller to the bracket at the armrest
and ghten the screws. (Figure 5).
5. Connect the controller wires marked R and L to the right and le motors respec vely.
6. Then fi x the wiring harness to the frame with plas c es. (Fig. 6)
7 Fit the footrests to the le and right sides of the frame (fi g. 8) Then turn the footrests over and
unfold. (fi g. 9)
8. The leg support strap should be placed over the right and le sleeves and then secured with tape.
9. Adjust the height of the leg rests, remove the lock nut on either side of the leg rest, remove the bolts
(see fi g. 11), adjust to the desired height, then insert the bolts and lock with the nut.
AT52304 insA6_multi.indd 13 AT52304 insA6_multi.indd 13
- 13 -
2023-12-22 13:27:21 2023-12-22 13:27:21