Olimpia splendid Bi2 WALL AR 1000 Manual De Instalación Y Mantenimiento página 32

4. Use the attached accessories parts and specified parts for installation.
Otherwise, it will cause the set to fall, water leakage, electrical shock and fire.
5. The appliance must be installed 2. 3m above floor. (fig. 2).
6. The appliance shall not be installed in the laundry.
7. Before obtaining access to terminals, all supply circuits must be disconnected.
8. The enclosure of the appliance shall be marked by word, or by symbols, with the
direction of the fluid flow (fIig. 1).
9. For electrical work, follow the local national wiring standard, regulation and this
installation instructions. An independent circuit and single outlet must be used.
If electrical circuit capacity is not enough or defect in electrical work, it will cause
electrical shock fire.
10. Use the specified cable and connect tightly and clamp the cable so that no external
force will be acted on the terminal.
If connection or fixing is not perfect, it will cause heat-up or fire at the connection.
11. Wiring routing must be properly arranged so that control board cover is fixed
properly.
If control board cover is not fixed perfectly, it will cause heat-up at connection
point of terminal, fire or electrical shock.
12. If the supply cord is damaged, it must be replaced by the manufacture or its service
agent or a similarly qualified person in order to avoid a hazard.
13. An all-pole disconnection switch having a contact separation of at least 3mm in all
poles should be connected in fixed wiring.
14. When carrying out piping connection, take care not to let air substances go into
refrigeration cycle.
Otherwise, it will cause lower capacity, abnormal high pressure in the refrigeration
cycle.
15. Do not modify the length of the power supply cord or use of extension cord, and
do not share the single outlet with other electrical appliances.
Otherwise, it will cause fire or electrical shock.
16. If the water leaks during installation, ventilate the area immediately.
17. After completing the installation work, check that the water does not leak.
18. The cool water in the unit is not lower than 3C, hot water is not higher than 70°C.
Water in the unit must clean, air quality must meet to the standard of PH=6. 5 and
7. 5.
19. Do not disconnect the electric power supply manually when the appliance is
running, since malfunctioning could occur.
20. Ask your dealer for installation of the air conditioner.
Incomplete installation performed by yourself may result in a water leakage,
electric shock, and fire.
21. Ask your dealer for improvement, repair, and maintenance.
Incomplete improvement, repair, and maintenance may result in a water leakage,
electric shock, and fire.
22. In the event of operating anomalies (e.g. strange noise, bad odour, smoke, abnormal
temperature rise, electric dispersions, etc.), switch the appliance off immediately
and disconnect the electric power supply.
For repair work contact solely the technical service centres authorised by the
manufacturer and ask for original spare parts to be used. Failure to do this can
affect the safety of the appliance.
23. Do not wet the indoor unit and the remote control.
Short circuits or fires may occur.
24. If a fuse blows, do not replace it with one that has a different amperage and do not
use cables of any type.
Use of wire or copper wire may cause the unit to break down or cause a fire.
25. It is not good for your health to expose your body to the air flow for a long time.
26. Do not insert fingers, rods or other objects into the air inlet or outlet. When the fan
EN - 4