Olimpia splendid Bi2 WALL AR 1000 Manual De Instalación Y Mantenimiento página 37

2 - INSTALLATION SEQUENCE
For successful installation of the appliance, perform the operations secon this order:
a. Select the location
b. Install the appliance
c. Connect the drain pipe
d. Connect the water pipes
e. Wiring
f. Test operation
3 - INSTALLATION OF THE APPLIANCE
3.1 - INSPECTING AND HANDLING THE UNIT
At delivery, the package should be checked and any dam-age should be reported immediately to the carrier
claims agent. When handling the unit, take into account the following:
a. Fragile, handle the unit with care.
b. Choose on before hand the path along which the unit is to be brought in.
c. Move this unit as originally package as possible.
d. When lifting the unit, always use protectors to prevent belt damage and pay attention to the
position of the unit's centre of gravity.
3.2 - INSTALLATION OF THE APPLIANCE
3.2.a - Place of installation
BEFORE INSTALLING THE UNIT, CHECK FOR THE PRESENCE OF ANY CABLES, HYDRAULIC
OR GAS PIPES, ETC. IN THE WALL OR FLOOR WITH THE USER; THIS WILL PREVENT
ACCIDENTS DUE TO DAMAGE.
Avoid installation in the following places to avoid inconveniences:
• Environments with high concentration of oils for machinery.
• Brackish environments, such as coastal areas.
• Environments with high concentration of sulphurous gases, such as spa facilities.
• Places where high frequency machinery is present, such as wireless equipment, welding machinery
and medical equipment.
• Environments with the presence of combustible gases and hazardous substances.
• Places with special environmental conditions.
• The environment must not be exposed to strong electro-magnetic waves.
• The place of installation must be distant from sources of heat, steam and inflammable gases.
Before installation, make sure that:
• The area with inlet and outlet connections must be free from obstructions.
• Make sure that curtains or other objects do not obstruct the air suction filters (Fig.10).
• The place of installation must be able to support the indoor unit.
• The place of installation must allow easy maintenance.
• The place of installation must guarantee sufficient space around the outdoor unit, as indicated in figure
2.
3.2.b - Assembly of the fixing plate
BEFORE FIXING THE PLATE, MAKE SURE THAT THE WALL WHERE THE APPLIANCE IS TO
BE INSTALLED CAN SUPPORT THE WEIGHT.
Operate as follows (figures 3-4):
a. Place the supplied drilling template (G) against the wall respecting the minimum distances from the
roof, from the floor and from the lateral walls; it is advised to keep the template in correct position
using adhesive tape (D).
b. Mark the drilling points (7 points recommended).
Bi2 WALL AR 1000 - 1200 - 1400
>>>>>
EN - 9