Olimpia splendid Bi2 WALL AR 1000 Manual De Instalación Y Mantenimiento página 44

.1 - CLEANING
7
7.1.a - Cleaning the appliance
a. Use a dry cloth to clean the appliance.
b. It is possible to use a cloth moistened with cold water to clean the appliance in case it's very dirty.
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
7.1.b - Cleaning the suction filter
In order to guarantee effective indoor air filtration and good working order of your appliance, it is essential to
periodically clean the air filters (7) every 2 weeks (in conditions of frequent use) (Fig.16). Operate as follows:
a. From the opening located in the upper part of the unit, extract the filter unit (7) through the tabs (7a) located
on the filter holder chassis (8) (Fig.16).
b. The filters(7) must be washed using a jet of water facing in the direction opposite to that of the accumulation
of dust or cleaned using a suction device (Fig.17).
c. If the dirt is particularly difficult to remove (such as grease or deposits of other types) the filters must be
previously immersed in a solution of water and neutral detergent.
d. Before re-introducing the filters, it is good practice to shake then to eliminate the water accumulating during
washing.
If the filters (7) are damaged, replace them.
e. Make sure that the filters (7) are completely dry.
f. Re-position the filters (7) correctly in the relative seats.
g. Suck possible fluff from the grille.
Do not use the appliance without the filter (7).
.2 - MAINTENANCE
7
If you do not intend to use the appliance for a long period of time, work as follows:
a. Activate the fan only mode for a few hours (approximately 8÷10 hours) to dry the interior of the appliance.
b. Stop the air appliance and disconnect the power supply.
c. Clean the air filter.
Checks before resuming use of the air conditioner:
a. Clean the filters after a long period of inactivity of the air conditioner.
b. Check that the air outlet or inlet are not obstructed (especially after a long period of inactivity of the air
conditioner).
EN - 16