Publicidad
Idiomas disponibles
Idiomas disponibles
GCS 35 2X18-EC
– follow the manufacturer's sharpening
and maintenance instructions for the
saw chain, decreasing the depth gauge
height can lead to increased kickback.
Additional safety instructions
■ Children and juveniles, with the exception
of apprentices older than 16 years and
under supervision, may not operate
the chain saw. The same applies for
persons who do not or do not sufficiently
know how to handle the chain saw. The
operating instructions should always be
ready to hand. Persons unfit or tired must
not operate the chain saw.
■ It is recommended that the first time user
should have practical instruction in the
use of the chain saw and the protective
equipment from an experienced operator
and that the initial practice should be
cutting logs on a saw horse or cradle.
■ Do not touch rotating chain.
■ Always use approved personal protective
equipment, this reduces the danger of
injury from thrown about cutting material
and accidental touching of the saw chain.
■ Do not operate chain saw near other
people, children or animals.
■ Do not operate chain saw after drinking
alcohol or under the influence of
intoxicating drugs or medication.
■ Ensure that children do not play with the
tool.
■ After use, always switch off the tool and
remove the battery.
■ Store the tool indoors in a dry and locked-
up place, out of reach of children.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value:
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
:
89 dB(A);
pA
:
100 dB(A);
WA
K = 11 dB.
:
4.38 m/s
h
K = 1.5 m/s
vibration values to change.
NOTE
The declared vibration total value(s) and
the declared noise emission level given in
this information sheet has been measured
in accordance with a measurement method
standardized in EN 62841 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organization of work patterns.
WARNING!
The vibration and noise emissions during
actual use of the power tool can differ from
the declared value in which the tool is used;
In order to protect the operator, user should
wear gloves and ear protectors in the actual
conditions of use.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
Technical data
Tool
2
Type
2
Rated voltage Vdc 2X18
No-load speed m/s 12
Guide bar
length
GCS 35 2X18-EC
Chain Saw
cm
35
19
Publicidad
