Publicidad
Idiomas disponibles
Idiomas disponibles
Chain oil tank
ml
volume
Weight
according
to"EPTA
kg
Procedure
01/2003"
Battery
18V
Weight of
kg
battery
Working
-10-40°C
temperature
Storage
< 50°C
temperature
Charging
4-40°C
temperature
Charger
CA 10.8/18.0, CA 18.0-LD
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1.
Sprocket wheel
2.
Lubrication hole
3.
Saw chain
4.
Guide bar
5.
Kickback brake
6.
Front handle
7.
Lock-off button
8.
Rear handle
9.
Trigger switch
10. Oil inspection window
11. Chain oil tank cap
12. Chain tension knob
13. Drive sprocket cover
14. Clamping knob
15. Guide bar cover
16. Position pin
17. Chain tension pin
18. Thread hole
20
150
3.85
AP 18.0/2.5
AP 18.0/5.0
AP 18.0/8.0
AP 18.0/2.5
0.4
AP 18.0/5.0
0.7
AP 18.0/8.0
1.1
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the cordless chain saw and check that
here are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting/replacing the battery
■ Press the two charged batteries into the
power tool until they click into place (see
figure B).
■ To remove, press the release button(1.) and
pull out the two batteries(2.) (see figure C).
■ Always attach or remove the two batteries
at the same time. The power tool cannot
work with one battery.
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Chain lubrication oil(see figure D)
WARNING!
This chain saw is not filled with chain oil.
It is essential to fill the product with chain
oil before using it! Never operate the
product without chain oil as this will result
in extensive damage to the product!
CAUTION!
Operating the saw chain dry or with
too little chain oil will decrease cutting
efficiency, shorten the product life span
and cause rapid wear to the saw chain and
guide bar from overheating!
Fill chain oil immediately when the oil level is
blow"Min" on the oil inspection window (10).
■ Position the product in a way that the chain
oil tank cap (11) faces upwards.
■ Open the cap (11) and fill the tank with
chain lubrication oil.
GCS 35 2X18-EC
Publicidad
