Costway NP11333 Instrucciones De Montaje página 6

Safety Warning: Assembly
1. Installation must be carried out by a competent adult.
2. Only suitable for soft soil, do not place on concrete, asphalt,
wood or other hard surfaces. Carpeting hard floors may not
prevent injuries. Falling on hard surfaces can result in head or
other serious injuries.
3. Cannot be used for rental or commercial purposes. For family
use & outdoors use.
4. This product is heavy, please be careful when using it.
5. The product should not be dragged across concrete
pavements or other rough surfaces.
6. Keep the product away from fire and flames.
7. Do not install the product in windy or rainy conditions.
8. The slide should not face the sun as this can make children
dizzy while using the product.
9. Should be placed on flat ground, if placed on inclined ground
may occur toppling.
10. Place the product on a soft ground at least 2 meters / 7 feet
away from any other objects (such as fences, trees, water
sources, hanging branches, clotheslines or wires). Make sure
the area around the product is safe. Check whether there are
sharp objects on the ground.
11. Electric wires must not be passed under the product.
12. Keep the blower (air pump) and power cord away from
children and water.
Place the blower (air pump) where it will not inhale dust or
leaves.
13. Note: During use, the blower (air pump) should remain on
and continue to inflate. Since the product is kept inflated by a
constant air flow, air leakage from the joint is normal and
necessary, so the product will not over-expand.
10
Assembly Instruction
1. Unfold the product in its entirety as the picture shows.
Roll the
Take out the
product and
product
expand it
2. Place the blower (air pump)
where it will not inhale dust or
leaves, and keep the blower (air
pump) and power cord away from
children and water. Note: Please
make sure the power supply is
safe and reliable. During use, the
blower (air pump) should remain
on and continue to inflate. After
stretching the air pipe, position the
blower (air pump) at the end of the
air pipe. Wind one end of the tube
around the blower (air pump), blow
out the air after tying. The inflation
tube should be straight and not
twisted. If necessary, adjust the
position of the blower (air pump). Then use ground piles to
firmly fix the blower (air pump) on the ground.
Open the Fully expand
produc the product
11