Makita DUR365U Manual De Instrucciones página 11

ASSEMBLY
WARNING:
• Always be sure that the tool is switched
off and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
• Never start the tool unless it is completely
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the handle
3
► 1. Grip 2. Handle 3. Screw
Insert the shaft of the handle into the grip. Align the
screw hole in the grip with the one in the shaft. Tighten
the screw securely.
2
► 1. Handle clamp 2. Screw
Place handle between handle clamp and handle holder.
Adjust the handle to an angle that provides a com-
fortable working position and then secure by firmly
hand-tightening knob.
Installing the guard
•
•
•
For metal blade
1
2
► 1. Clamp 2. Bolt
For nylon cutting head or plastic
blade
1
•
11 ENGLISH
WARNING:
Never use the tool without the guard illus-
trated in place. Failure to do so can cause
serious personal injury.
Always use the tool with the approved combina-
tion of the safety equipments. Otherwise contact
with a cutting tool may cause serious injury.
Permitted combination for the cutting tool and
the guard may differ from country to country.
Follow your region's regulations.
2
CAUTION:
Take care not to injure yourself on the cutter
for cutting the nylon cord when installing nylon
cutting head or plastic blade.
1