Overload Protection - Makita DUR365U Manual De Instrucciones

Overload protection

On
If the tool is overloaded by entangled weeds or other
debris, the tool stops automatically, and all of the speed
indicators blink. In this situation, turn the tool off and
stop the application that caused the tool to become
overloaded. Then turn the tool on to restart.
Overheat protection for tool
On
When the tool is overheated, the tool stops automat-
ically, and all of the speed indicators and the battery
indicator blink about 60 seconds. In this situation, let the
tool cool down before turning the tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the tool does not operate even when
the switches are operated, remove the batteries from
the tool and charge the batteries.
Remaining battery capacity
indication
(Country specific)
2
► 1. Battery indicator 2. CHECK button
Press the check button to make the battery indicators
show the remaining battery capacities. The battery
indicators correspond to each battery.
Off Blinking
Off Blinking
1
Remaining battery capacity
indication
Battery indicator status
Blinking
On Off
Power switch action
WARNING:
• Before inserting the battery cartridge into
the tool, always check to see that the switch
trigger actuates properly and returns to the
"OFF" position when released. Operating a
tool with a switch that does not actuate properly
can lead to loss of control and serious personal
injury.
1
► 1. Main power button
Press and hold the main power button for some sec-
onds to turn on the tool.
To turn off the tool, press and hold the main power
button again.
9 ENGLISH
Remaining battery capacity
50 % - 100 %
20 % - 50 %
0 % - 20 %
Charge the battery