Publicidad
Idiomas disponibles
Idiomas disponibles
______________________________________________________________________________
A plug-in Phoenix terminal block on the rear panel accommodates the remote control connections
and also the low-voltage outputs. There are three inputs which control power state; one
programmable 12V dc output; and one programmable auxiliary relay providing normally-open
contacts. The inputs can be controlled by an applied DC voltage from 5V to 30V, by a contact
closure, or by different types of switch; the input selection being made during programming. The
inputs and 12V output are designed to withstand incorrect connections including polarity reversal
and shorts.
11 Features
• Unsurpassed SurgeX
®
• SurgeX
Impedance Tolerant
®
®
• SurgeX
ICE
Inrush Current Elimination
• All functions easily programmed from the front panel
• Accepts both DC voltage and contact closure control inputs
• Two or more units can be ganged or cascaded together for larger systems
• Programmable auxiliary relay output can be used to control other SurgeX
• Programmable 12 Volt dc output can be used to control other SurgeX
LEDs
• Auxiliary relay or 12 Volt dc output can be programmed to provide confirmation feedback
• Built-in AC Voltmeter
• Built-in AC Ammeter
• Built-in Power Calculation
• Separate over-ride input can be used to force unit off or force unit on
• Adjustable under-voltage and over-voltage shut-down
• Optional restore after power failure feature
12 Installation
The SurgeX XR315 is designed to rest on a flat surface or to be installed in a 19 inch equipment
rack and requires one unit (1-U) of rack space. To place the XR315 on a flat surface, attach the
four rubber feet (included). To install in an equipment rack, use eleven 6-32 Phillips flat head
screws (included) to attach the removable rack-mounting brackets (included) to the sides of the
product. Use the four thumbscrews provided with the product to secure the rack ears to the rack
rails. These screws can be tightened by hand and do not require tools. Connect power to the unit
by plugging the cord into a 120V ac, 15 amp wall or floor receptacle. Do not plug the unit into a
relocatable power tap. *CAUTION: Do not install this device if there is not at least 10 meters
(30 feet) or more between the electrical outlet and the electrical service panel.
© 2024 AMETEK Electronic Systems Protection / Soporte técnico: 1-800-645-9721 / surgex.com
XR315
®
Advanced Series Mode
®
EMI/RFI filtering
®
surge elimination
®
Manual de usuario
®
products
products or drive
30
Publicidad
