Publicidad
Idiomas disponibles
Idiomas disponibles
______________________________________________________________________________
13 Quick Start
This section is intended to allow users with a simple straightforward system incorporating a single
XR315 to get up and running with the minimum of effort. If this is not the case then skip this
section and go directly to the section on detailed programming (section 5). If you are going to
follow the quick start instructions, you only need to perform the following steps since the unit has
been shipped with default settings suitable for basic operation.
6. Make all connections as per section 3.
7. Insert a screwdriver in the hole labeled Select and turn it one click clockwise. Press the power
button and you will see the first menu item "Unused" on the display. This is a function that is
not available in the current software/hardware configuration.
8. Advance Select one click to get the second menu item "Up & Down Inputs". Select the option
required for the install by referring to section 3.2.1 and set the option by rotating Adjust.
9. If you have connected an LED to the 12V dc output for remote signaling, step through the
menu until you reach "12V dc Output". Then advance Adjust to select "LED". This selection
will make the remote LED mimic the LED on the front panel which flashes while the unit is
powering up or powering down.
10. Turn Select fully counter-clockwise and press the power button to exit programming.
Although the above steps are all that are required to get the XR315 running, you may want to take
a look at the following programming options to see if you want to make use of any of these
functions. You will find these listed on the reverse side of the Programming and Connection
Guide, and they are near the end of the menu that you step through by turning Select.
Low Voltage Shutdown
High Voltage Shutdown
Power Fail Restore
© 2024 AMETEK Electronic Systems Protection / Soporte técnico: 1-800-645-9721 / surgex.com
XR315
Shuts unit off if AC voltage drops below the set point
Shuts unit off if AC voltage rises above the set point
Turns unit back on after a power failure if unit
was powered up when the power failed
Manual de usuario
34
Publicidad
