Operator Selectable Tone (Ost); Voice Operated Transmission (Vox) - Kenwood TK-2170 Manual De Instrucciones

O S
PERATOR ELECTABLE
You can change the preset encode and decode tones for the
selected channel. Your dealer can program up to 40 tones on
your transceiver.
To turn OST ON or OFF, press the key programmed as OST.
• The OST indicator (
this function is activated.
To change the preset encode/decode tones:
1 Press and hold the key programmed as OST for
approximately 1 second.
• The OST name appears on the display.
2 Press the <B and C> keys, rotate the selector, or enter an
appropriate number using the DTMF keypad to select your
desired encode/decode pair.
3 Press the Side 1, S, or
and return to normal operation.
V O
OICE PERATED
VOX can be activated or deactivated by your dealer. VOX
operation allows you to transmit hands-free. This feature can
only be used if you are using a supported headset.
When operating VOX, you must set a VOX Gain level. This
setting allows the transceiver to recognize sound levels. If the
microphone is too sensitive, it will begin transmitting when
there is noise in the background. If it is not sensitive enough,
it will not pick up your voice when you begin speaking. Be
sure to adjust the VOX Gain level to an appropriate sensitivity
to allow smooth transmission.
To set the VOX Gain level, perform the following steps:
1 Connect the headset to the transceiver.
• The VOX function does not activate when a headset is not
connected to the accessory terminal of the transceiver.
22
T (OST)
ONE
key to accept the new setting
T
RANSMISSION
) appears on the display when
(VOX)