Publicidad
Idiomas disponibles
Idiomas disponibles
Lithium ion batteries have many advantages over other batteries, mainly due
to their flexibility. They don t have to be completely charged every time they are
used, nor do they have to be used continuously or fully drained each time.
BATEC MOBILITY only uses batteries ith the safest technology available, includ-
ing the BMS smart battery management system.
HANDBIKE BATEC HIBRID batteries don t require any maintenance.
4.8.1 BASIC BATTERY USE
Inserting and removing the HANDBIKE BATEC HIBRID battery
You don t need to touch any connectors to insert or remove the battery from your
HANDBIKE BATEC HIBRID, as this is done automatically. ( ee fig. 29)
•
To remove the battery: Turn the key to the REMOVE BATTERY position (OPEN).
Grab the handle of the battery and pull up gently until the battery comes fully
of the guide. ( ee fig. 27)
•
To insert: Grab the battery by the handle. Set the lo er right corner of the bat-
tery in the side support tab until it clicks into the guide. Slide the battery do n
slo ly until it is resting completely in the mount. ( ee fig. 28)
IMPORTANT!
If you leave the battery in the OFF AND REMOVE KEY
position (OFF), you on t be able to remove it.
Connecting the battery:
To connect the HANDBIKE BATEC HIBRID battery, simply turn the key to the ON
position and use your HANDBIKE BATEC HIBRID normally. ( ee fig. 17)
The battery charging system is protected by the smart battery management sys-
tem (BMS), hich cuts po er if there is a surge or if any of the battery cells are
too discharged.
CAREFUL!
Never, under any circumstances, use the discharging port on the battery to
charge it or po er it in any ay, hether ith an external po er source or regen-
erative brake system.
Charging the battery:
•
The HANDBIKE BATEC HIBRID battery is charged ith the 3-pin LR port on the
side of the battery. ( ee fig. 30)
– 18 –
ITH DETACHING LOCK
Publicidad
