Publicidad
Idiomas disponibles
Idiomas disponibles
4.9.
EIGHTS
The HANDBIKE BATEC HIBRID models are equipped
improve traction. The eights are located on the fork, one on each side. Each one
eighs 2.4 kg. To make it easier to transport the HANDBIKE BATEC HIBRID, the
eights can be removed.
•
To remove the eights:
1. Hold the weight with one hand, press on the red button and tilt it so the bot-
tom part comes a ay from the HANDBIKE BATEC HIBRID. ( ee fig. 31)
2. Pull the eight out completely. ( ee fig. 31)
•
To insert the weights:
1. Hold the weight tightly in one hand. Tilt it slightly and insert the two tabs into
the slit on the eight mount slot. ( ee fig. 31)
2. Push the bottom of the eight in ard until it clicks into place. ( ee fig. 31)
5. INSTALLATION AND ADJUSTMENTS
5.1. INSTALLATION OF THE HANDBIKE BATEC HIBRID ON A
HEELCHAIR
To anchor a HANDBIKE BATEC HIBRID to a
BATEC DOCKING-BAR (pat. pending). The BATEC DOCKING-BAR can be installed
on most heelchairs on the market, hether fixed or folding frame.
IMPORTANT!
An updated list of
available in the support section of the BATEC MOBILITY ebsite.
The HANDBIKE BATEC HIBRID must be installed on a
professional authorised by BATEC MOBILITY. Contact BATEC MOBILITY to find the
authorised installation professional closest to you.
5.2. USER ADJUSTMENTS
Once the HANDBIKE BATEC HIBRID is properly installed on the heelchair, there
are several adjustments that must be made in order to fit the HANDBIKE BATEC
HIBRID to the user s level of mobility, type of disability and size.
These adjustments can be done easily
ith the HANDBIKE BATEC HIBRID and basic mechanical kno ledge.
heelchairs compatible
– 2 –
ith standard
heelchair, you must first install a
ith the HANDBIKE BATEC HIBRID is
heelchair by a qualified
ith the tools and instructions provided
eights to
Publicidad
