Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT!
Sand and salt
ater can damage some parts of the HANDBIKE BATEC HIBRID
after prolonged contact. Clean it after use in these conditions.
Cleaning front and rear wheels:
Make sure the front heel and rear heels turn freely and eliminate any dirt.
Checking brakes:
Make sure that hen you squeeze the brake levers, both have su cient contact
ith the disc for e ective braking.
Make sure the brake callipers and disc are properly attached to their respective
anchors.
To adjust the brake pads, al ays do the inside pad first and then the outside one.
Greasing cables and chains:
Apply a drop of grease or light coat of Teflon spray to the cable connecting levers and
to chains, after removing the old grease. After applying, remove any excess grease.
Greasing the transmission mechanism:
Apply a drop of grease or light coat of Teflon spray to the transmission mecha-
nism, after removing the old grease. After applying, remove any excess grease.
Having HANDBIKE BATEC HIBRID serviced by an authorised distributor:
The recommended preventive maintenance and any repairs to your BATEC ELEC-
TRIC HANDBIKE must be done by a company authorised by BATEC MOBILITY.
Replacing tyres and inner tubes:
Before installing a ne inner tube, check the base of the rim and inside
all of
the tyre to remove any foreign bodies and, if necessary, clean ell. Check the con-
ditions of the rim tape, particularly around the valve hole. Only strong, properly
placed rim tape can provide long-term protection against damage to the inner
tube caused by burrs and sharp spoke heads.
Before inflating the inner tube, check the hole tube to make sure it hasn t got
stuck bet een the tyre and the rim. Carefully pull on the valve and extract it for
optimal installation.
Reusing the BATEC ELECTRIC HANDBIKE
The BATEC ELECTRIC HANDBIKE can be reused. If you would like to reuse it,
please contact the distributor where you purchased it and they will take care of
– 27 –
Publicidad
