Publicidad
Idiomas disponibles
Idiomas disponibles
Functional Description
A
D E F G H
Figure 1:
A – Connector Harness Assembly
B – Booster Cable Assembly
C – Safety Warnings and Cautions
D – Weather Cap
E – Handle
F – Mounting Plate
G – Screw (2)
H – Hex Nut (2)
I – Lock Washer (2)
Symbology
SYMBOLOGY
REFER TO INSTRUCTION
MANUAL/BOOKLET
WEAR EYE PROTECTION
RISK OF FIRE
RISK OF EXPOSION
RISK OF ENTANGLEMENT
RISK OF SHOCK
BC25500PA-Z Rev. B
B
C
I
Operation
Assembly
1. Separate the booster cable assembly from the
connector harness assembly by grasping each plug
and pulling them away from each other.
2. Install handle to plug of booster cable assembly (long
cables with clamps) using the two hex nuts, lock
washers, and screws packaged with it.
A
B
A – Handle
B – Hex Nut (2)
C – Plug
D – Lock Washer (2)
E – Screw (2)
Installation
1. Examine the vehicle on which the connector harness
assembly will be installed. Choose a flat, rigid,
structurally sound surface, such as the top of the front
bumper, for mounting the plug so that it can be reached
without opening the vehicle's hood. Check that the
cables can be routed to the battery terminals without
straining or kinking them and that they are free of
obstructions and moving parts (such as fan blades or
drive belts) and sources of high heat (such as exhaust
manifolds). Finally, make sure that the underside of the
mounting surface is accessible so that all the required
hardware can be installed to secure the plug.
3
CE MARK
DO NOT THROW IN GARBAGE
PROPERLY DISPOSE AT AN
APPROVED RECYCLING
CENTER
Figure 2:
E
D
C
(01/17)
Publicidad
