Eaton TRIPP LITE Serie Manual Del Propietário página 5

Installation
Notes:
1) Supports the connection of three monitors at the same time through DisplayPort
MST Mode.*
2) To ensure proper function of the five USB (4 USB-A and 1 USB-C) hub ports, make
sure to plug in the included external power supply or the host device's PD charging
power supply to the unit.
3) When the included 72W power adapter is connected to the DC port, it supplies
power to charge the host PC first (up to 60W) with the rest of the power being
supplied to the dock.
4) When the PD charging power adapter is connected, 15W of total power will be
reserved first to guarantee the functioning of the product. The rest of the power will
be used to charge the host PC (the power that the host PC can get depends on the
result of PD protocol negotiation).
5) When the DC port is connected prior to the Type-C PD Charging port, the docking
and host PC are powered from the DC port, with the Type-C port as an alternative
power source.
6) When the Type-C PD Charging port is connected (with a PD power adapter) prior to
the DC port, the docking and host PC are powered from the Type-C port with the DC
port as an alternative power source.
7) If the active power source (power source that is supplying power) is unplugged, the
alternative power port will be switched on automatically to be the active power
source. In this case, the connected devices will get disconnected for a few seconds
and then reconnect automatically.
8) See Optional Accessories section for suggested cables.
9) When the unit is connected to the USB-C port on your computer and to a network
via Cat5e/6 cabling, a network connection will be automatically established. If no
connection is made, you can manually establish one by going to your computer's
network settings page. For example, on a Mac, you would navigate to the Network
section found in System Preferences, click the "Assist Me" button to get to the Network
Setup Assistant, then follow the prompts to establish a connection.
* See Multi-Monitor Requirements section for details.
1. Connect the included power supply between the unit and a power
source and/or the included USB Type-C cable between the unit and a PD
charging adapter (not included).
Note: The USB hub ports may go into overcurrent protection if high-powered USB
peripherals are attached without the external power adapter being connected. The
USB Type-C PD Charging port can also be used for data transfer.
5