Publicidad
Idiomas disponibles
Idiomas disponibles
C1-8—
Pull out the main brush caps.
C1-9—
After removing the tangled hair or
dirt at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place.
Notes:
• Main brush should be wiped down with a wet cloth and left
to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Side Brush
C2
* Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
Omnidirectional Wheel
C3
* Clean as required.
C3-1—
Use a tool, such as a small screwdriver,
to pry out the axle and take out the
wheel.
Note:
The omnidirectional wheel bracket cannot be removed.
C3-2—
Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
Main Wheels
C4
* Clean monthly.
Clean the main wheels with a soft, dry cloth.
Dustbin and Water Tank
C5
Combo Unit
* Clean weekly and replace the filter every 6-12 months
C5-1—Press the latch to remove the unit.
Remove the washable filter then
empty the dustbin.
C5-2—Empty the water tank of unused water.
C5-3—Fill the dustbin with clean water and
gently shake it. Then pour out the
dirty water.
Note:
To prevent blockage, only use clean water without any
cleaning liquid.
C5-4—Rinse the filter repeatedly and tap it to
remove as much dirt as possible.
Note:
Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C5-5—Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note:
Purchase an additional filter and alternate if necessary.
Mop Cloth
C6
* Clean after each use and replace every 3-6 months
Remove the mop cloth from mop cloth
mount. Clean the mop cloth and air-dry it.
Note:
A dirty mop will affect the mopping performance. Clean
it before use.
Robot Sensors
C7
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C7-1—Dock Locator
C7-2—Reactive Tech Obstacle Avoidance
Sensor
C7-3—Wall Sensor
C7-4—Cliff Sensors
Charging Contact Areas
C8
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the charging dock and the robot.
10
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Basic Parameters
Robot
Model
Q80ULL
14.4V/5200mAh (TYP)
Battery
lithium-ion battery
Rated Input
20VDC 1.2A
Charging Time
< 6 hours
Note: The serial number is on a sticker on the underside of
the robot.
Charging Dock
Model
CDZ12RR or CDZ20RR
Rated Power
28W
Rated Input
100-240VAC
Rated Output
20VDC 1.2A
Rated Frequency
50-60Hz
14.4V/5200mAh (TYP)
Charging Battery
lithium-ion battery
Publicidad
