Publicidad
GB
1. About this document
Please read carefully and keep in a safe place.
• Under copyright. Reproduction either in whole or
in part only with our consent.
• Subject to change in the interest of technical
progress.
Symbols
!
Hazard warning!
Reference to other information in the
...
document.
2. General safety precautions
Disconnect the power supply before
!
attempting any work on the unit.
• During installation, the electric power cable being
connected must not be live. Therefore, switch off
the power first and use a voltage tester to make
sure the wiring is off-circuit.
• Installing the LED luminaire involves work on the
mains voltage supply.
This work must therefore be carried out pro-
fessionally in accordance with national wiring
regulations and electrical operating conditions.
(e.g. DE-VDE 0100, AT-ÖVE / ÖNORM E8001-1,
CH-SEV 1000)
• Only use genuine replacement parts.
• Repairs may only be made by specialist work-
shops.
3. RS PRO LED P1 / FLAT
RS PRO LED P2 / FLAT
RS PRO LED P3
Proper use
– Light with LEDs as the source of light
– Suitable for indoor wall and ceiling mounting
– As single light or interconnected with the
sensor-switched version
Note:
When installing, please always allow a distance of
at least 3 m to Wi-Fi routers or access points.
Package contents for P1 / P2 / P3 (Fig. 3.1)
Package contents for P1 FLAT / P2 FLAT (Fig. 3.2)
Product dimensions for P1 / P2 / P3 (Fig. 3.3)
Product dimensions for P1 FLAT / P2 FLAT
(Fig. 3.4)
Product components
RS PRO LED P1 /
RS PRO LED P1 FLAT (Fig. 3.3)
RS PRO LED P2 / RS PRO LED P1 FLAT /
RS PRO LED P3 (Fig. 3.4)
A Electronics enclosure
B Connecting terminal
C Sealing plug
Luminous intensity distribution (Fig. 3.7)
4. Electrical connection
• Switch OFF power supply (Fig. 4.1)
Wiring diagram (Fig. 4.1)
The mains power supply lead is a 3-core cable:
L
= phase conductor (usually black, brown or
grey)
N = neutral conductor (usually blue)
PE = protective-earth conductor (green / yellow)
If you are in any doubt, identify the conductors
using a voltage tester; then disconnect from the
power supply again. Connect phase (L) as well as
the neutral conductor (N) to the terminal.
Important:
Incorrectly wired connections will produce a short
circuit later on in the product or your fuse box. In
this case, you must identify the individual con-
ductors once again and reconnect them. A mains
power switch for turning the unit ON and OFF may
of course be installed in the mains supply lead.
The light source of this luminaire cannot be re-
placed. If the light source needs to be replaced (e.g.
at the end of its service life), the complete luminaire
must be replaced.
Note:
Do not make direct contact with the LEDs.
– 10 –
- 10 -
Publicidad
