Publicidad
5. Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
• When installing the LED light, make sure the
installation site is not subject to vibration.
• Not suitable for ceiling mounting with surface-
mounted power supply lead. (Fig. 5.1)
Mounting procedure
• Detach shade from enclosure.
• Mark drill holes (Fig. 5.2).
• Drill holes and fit wall plugs.
• Pierce sealing plug for power supply lead
(Fig. 5.3).
• Concealed wiring (Fig. 5.4).
• With spacers for surface mounting (Fig. 5.5).
• Connect conductors (Fig. 5.6 + 5.7).
• Switch ON power supply (Fig. 5.8).
• Fit shade (Fig. 5.8).
6. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmen-
tally compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be col-
lected separately and recycled in an environmentally
compatible manner.
Important note: The control gear cannot be replaced.
7. Manufacturer's Warranty
Manufacturer's warranty of STEINEL GmbH,
Diesel strasse 80-84, DE-33442 Herzebrock-
Clarholz, Germany
All STEINEL products meet the highest quality
standards.
For this reason, we, the manufacturer, are pleased
to provide you, the customer, with a warranty under
the following terms and conditions:
The warranty covers the absence of deficiencies
which are proven to be the result of a material
defect or fault in manufacturing and which are
reported to us immediately after detection and
within the warranty period. The warranty shall cover
all STEINEL Professional products sold and used in
Germany.
Our warranty cover for consumers
The provisions below apply to consumers.
A consumer is any natural person who, on entering
into the purchase transaction, neither acts in
exercising their commercial nor their self-employed
activity.
You can opt for warranty cover in the form of
repair or replacement which will be provided free
of charge (if applicable, in the form of a successor
model of the same or higher quality) or in the form
of a credit note.
In the case of sensors, floodlights, outdoor and
indoor lights, the warranty period for the STEINEL
Professional product you have purchased is:
5 years
for hot-air and hot-melt gluing products: 1 year
in each case from the date on which the product
was purchased.
We shall bear the shipping costs but not the trans-
port risks involved in return shipment.
Our warranty cover for entrepreneurs
The provisions below apply to entrepreneurs. Entre-
preneur is a natural or legal person or partnership
with legal personality who or which, on entering into
the purchase transaction, acts in exercising their or
its commercial or self-employed activity.
We have the option of providing warranty cover by
rectifying deficiencies free of charge, replacing a
product free of charge (if applicable, in the form of
a successor model of the same or higher quality) or
by issuing a credit note.
In the case of sensors, floodlights, outdoor and
indoor lights, the warranty period for the STEINEL
Professional product you have purchased is:
5 years
for hot-air and hot-melt gluing products:
1 year
in each case from the date on which the product
was purchased.
– 11 –
GB
Publicidad
