Publicidad
Idiomas disponibles
Idiomas disponibles
Attachment Model A576 - Sanding / Grinding Guide
Using the Sanding/Grinding
Guide Attachment
Do not use keyless chuck
(model 4486) with this at-
tachment. Only use a collet and collet nut.
For use with 1/2" or less
sanding
stone accessories only.
Router bits are not al-
lowed for use with the
Sanding/Grinding Guide attachment.
(Fig. 11, 12, 13)
The guide comes completely assembled and
ready to use for sanding and grinding appli-
cations up to ½" ( 13 mm) thick.
The guide has a 90 and 45 degree bevel for
various sanding applications.
Installation instructions:
1. Remove the Nose Cap 5 from the end of
the tool and set nose cap aside (Fig. 11).
The original nose cap must be reinstalled
when this attachment is not used.
2. Loosen the Collet Nut 3, insert accessory,
and tighten the collet nut (Fig. 12).
3. Thread the attachment A onto the thread-
ed portion of the housing collar B (Fig.
12).
4. To adjust the depth of the attachment A
(Fig. 13): Loosen the wing knob C, adjust
the depth, and tighten the wing knob C.
16
1605A0014P 3100 202303.indd 16
page heading
Fig. 11
and
grinding
Fig. 12
Fig. 13
5
3
A
A
C
B
4/5/23 7:05 AM
Publicidad
