Publicidad
Idiomas disponibles
Idiomas disponibles
29822:
1 x WP/A Angle Polisher
1 x Operating instructions and safety gui-
delines
1 x Foam backing pad
1 x Polishing sponge
1 x Lambskin polishing disc
1 x Polishing felt
12 x Grinding wheels (K 2000)
1 x Microfi bre cloth
Polishing emulsion
4 Technical data
Motor:
Voltage:
Device:
Length:
Weight:
Spindle velocity:
Maximum polishing tool
diameter:
Noise development:
General measuring
uncertainty:
Grip vibration:
Charger:
Mains voltage:
50/60Hz
Output voltage:
Charging current:
Battery:
Rechargeable lithium-ion battery
Nominal/charging voltage: 10.8V/12.6V
Energy/Capacity:
5 Noise/vibration information
The information on vibration and noise emissi-
on has been determined in compliance with the
prescribed standardised and normative measu-
ring methods and can be used to compare elec-
trical devices and tools with each other.
- 18 -
10,8 V
approx. 320 mm
approx. 950 gr.
800-2800 rpm
50 mm
< 70 dB(A)
K=3dB
≤ 2.5 m/s
2
100-240V~,
12.6 V
1 A
28.19Wh/2.61Ah
3 INR 19/66
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
Warning!
Depending on the operating conditions while
operating the device, the actually occurring
emissions could differ from the values speci-
fi ed above!
Please bear in mind that the vibration and
noise emission can deviate from the values
given in these instructions, depending on the
conditions of use of the tool. Always ensure
you have an adequately sharp saw blade and a
well-maintained drive. Poorly maintained tools,
inappropriate working methods, different work
pieces, too high a feed or unsuitable work pie-
ces or materials or unsuitable bits and cutters
can signifi cantly increase the vibration load and
noise emission across the entire work period.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched off,
or is running but is not actually in use. This can
clearly reduce the vibration and noise load ac-
ross the entire work period.
Warning!
• To reduce vibrations, make sure your tool
and the cutting disc or the saw blade are in
proper condition!
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
• Take breaks if necessary when working with
the device!
6 Commissioning and operation
Charging the battery (Fig. 2 and 3)
Publicidad
