Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO ADD WATER
Filling up the water tank
1. Lift the water tank cover, then grasp the
water tank handle and remove the water
tank.
2. Turn the water tank cap in a counterclockwise direction to detach.
3. Put in water and turn the water tank cap in a clockwise direction
until you hear a click as it locks.
Tips
Precautions when reinstalling the water tank
When inserting the cistern into the purifier, push it all the way in until you hear a click. If the cistern is
not completely installed, it may cause leaks or faulty operation. If the water tank and cistern are not
correctly installed, a "refill water" notification is displayed on the front.
If you push the water tank and cistern
all the way in so they are correctly
installed, the "refill water" notification
will shut off and the purifier will operate
normally.
Tips
- If you press the cap down too hard to tighten it, it may be damaged or not
fully closed and may leak water.
- When tightening the cap, hold its sides and turn it to lock it in place
- It is best to fill the water tank with water all the way to the MAX mark.
- The water tank lasts approximately 12 hours at silent air volume and 4 hours
at L3 air volume, and it is best to check the amount of water remaining before
using the humidification feature.
- When reinstalling the water tank, hold the inner handle to ensure your fingers
are not caught.
Maintenance
Click!
Click!
ENGLISH / 16
Publicidad
